LED Control IRremote. h v3

#include <IRremote.h> // include the IRremote library
#define IR_RECEIVE_PIN 2
long data = 0; 
int redPin = 9; //select the pin for the red LED
int bluePin = 10; // select the pin for the  blue LED
int greenPin = 11; // select the pin for the green LED
void setup() {
  Serial.begin(9600); // begin serial communication with a baud rate of 9600
  IrReceiver.begin(IR_RECEIVE_PIN, ENABLE_LED_FEEDBACK);
  pinMode(redPin, OUTPUT);
  pinMode(bluePin, OUTPUT);
  pinMode(greenPin, OUTPUT);
void loop() {
  if (IrReceiver.decode()) {
    if (IrReceiver.decodedIRData.decodedRawData != 0) {
      data = IrReceiver.decodedIRData.decodedRawData;
    switch (data) { // compare the value to the following cases
      case 3910598400:
        Serial.println("1, Red");
        setLed(255, 0, 0);
        break ;
      case 3860463360:
        Serial.println("2, Orange");
        setLed(255, 128, 0);
        break ;
      case 4061003520:
        Serial.println("3, Yellow");
        setLed(255, 255, 0);
        break;
      case 4077715200:
        Serial.println("4, Green");
        setLed(0, 255, 0);
        break ;
      case 3877175040:
        Serial.println("5, Blue");
        setLed(0, 0, 255);
        break ;
      case 2707357440:
        Serial.println("6, Intigo");
        setLed(127, 0, 255);
        break ;
      case 4144561920:
        Serial.println("7, Violet");
        setLed(255, 0, 255);
        break ;
    IrReceiver.resume();
void setLed(int r, int g, int b)